mcatrophy

Since you say you've changed the clutch plates, the most likely cause would be something wrong with the clutch assembly. In fact I got...

Just a data point. I'm on my fourth FJR. All of them measure(d) 14.2 - 14.3 volts on the battery while the engine is running at idle...

As escapefjrtist says, removal of that centre panel is a little daunting, a fair amount of plastic flexure is needed. But it's quite...

Yoiks. Good catch.

A little help. I had occasion to remove panels on my 2014, essentially the same as your 2017, I used words from another forum member...

One possibility that comes to mind, separate all the pages, put each into a clear plastic sleeve, they come with holes in the sleeve for...

That's why I stick to the BT023. Even though it wears to a V, its handling remains good right until it reaches the 1mm indicators, when...

My experience too. If on the centre stand (very rare) I usually fill to the level plate in the filler, if on the side stand, my aim is...

To try to help with your queries, the bike does fine at low speeds, the only time you need to be careful is when coming to a stop, if...