Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Fault Code 12
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="MotoMike" data-source="post: 1463401" data-attributes="member: 92743"><p>So.......my new relay arrived today. I had a devil of a time removing the electrical wire connector from the old relay as the connector was totally corroded where the female side of the spade connectors on the cable side slide over the male pins on the relay. I cleaned off the female connectors by scraping them and flushing with electrical contact cleaner. I blew the connector out with compressed air from a can, then reconnected and re-installed everything.</p><p></p><p>When I tried to start the bike I saw no code 12 and no check engine light. The starter turned vigorously, but the engine did not fire up. I tried the Wide Open Throttle manouver three times, letting the starter turn for a count of 15 Mississippis each time. Still no joy.</p><p></p><p>I called up diagnostic code 62 which showed 3 fault codes in the memory. I called up diagnostic code 61 which showed those codes to be 12, 14 and 30.</p><p></p><p>I have 2 questions:</p><p>1) How do I erase the fault codes contained in the memory? I figure if I erase the codes and one or more recurs, that might narrow things down.</p><p>2) Where do I go from here?</p></blockquote><p></p>
[QUOTE="MotoMike, post: 1463401, member: 92743"] So.......my new relay arrived today. I had a devil of a time removing the electrical wire connector from the old relay as the connector was totally corroded where the female side of the spade connectors on the cable side slide over the male pins on the relay. I cleaned off the female connectors by scraping them and flushing with electrical contact cleaner. I blew the connector out with compressed air from a can, then reconnected and re-installed everything. When I tried to start the bike I saw no code 12 and no check engine light. The starter turned vigorously, but the engine did not fire up. I tried the Wide Open Throttle manouver three times, letting the starter turn for a count of 15 Mississippis each time. Still no joy. I called up diagnostic code 62 which showed 3 fault codes in the memory. I called up diagnostic code 61 which showed those codes to be 12, 14 and 30. I have 2 questions: 1) How do I erase the fault codes contained in the memory? I figure if I erase the codes and one or more recurs, that might narrow things down. 2) Where do I go from here? [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Fault Code 12
Top