dunhamg
Well-known member
I'm adding this to the technical/mechanical problems as it's probably a better fit than the farkle forum section.
I've got a PCIII installed and have had the O2 sensor unplugged for about 50,000 miles and now this past weekend the check engine light came on and the dash is showing a fault code of 24.
I have gone in to reset the codes. It showed that there were several codes and now it says that there is one fault code stored and I can't get that one to reset. In addition the light stays on.
Diag 60 and 61 both read 00, but diag 62 says 1 this doesn't change after flipping the kill switch off and on per the reset instructions.
Thanks for any additional help in this matter.
I've got a PCIII installed and have had the O2 sensor unplugged for about 50,000 miles and now this past weekend the check engine light came on and the dash is showing a fault code of 24.
I have gone in to reset the codes. It showed that there were several codes and now it says that there is one fault code stored and I can't get that one to reset. In addition the light stays on.
Diag 60 and 61 both read 00, but diag 62 says 1 this doesn't change after flipping the kill switch off and on per the reset instructions.
Thanks for any additional help in this matter.