escapefjrtist's latest activity

For '15s there is a different complete manual for ES bikes. Since ES was just introduced in '14 MY, I imagine it's same case. ~G

Yes, it'll work just fine. Reports indicate running that size will also correct speedometer error, at least on GEN III's. ~G

Small hydraulic line is indeed the stepped adjustable spring preload. Since you opened that system, on reassembly you'll need to bleed...

I'd recommend getting it 1) fixed in CO and riding it or 2) trailering it back rather than shipping it. Getting it across the border is...

Thanks to all the suggestions, I've got an Excel spreadsheet up and running as I figure I'll spend the next few months planning out...

Since you asked...if I were in your shoes I would arrange a trip south to retrieve the bike and have work done in Calgary. Road trip...

Looks correct. I used the bottom pivot bolt with longer hex on clutch side. Seems like that's what the Suzuki instructions indicate...

Mid process of swapping for thinner shims, dropping all the intake shim by 5/100th of a mm. Factory shims were mix of 1.85 and 1.90 mm.

I'll look... ~G

I have been following this thread and decided to order them today. I do appreciate all the knowledge on this forum.

Good information, thanks. ~G

Yes, this is the first time needing to shim the valves. Here are the measurements.

Mine are equally spaced at brake and clutch pivots. I used the pivot bolt with the longer (taller) hex on clutch side and the pivot with...

Good report for 100K plus miles. I'm anticipating needing to shim at least three (3) intakes on my '15 at next (75k) check. Next check...

Done