RossKean's latest activity

Gary, it's not a FuzeBlock. It is a SoCalMotoGear power distribution block: Here is the notice below they sent me. I did not use on...

Shall we assume that it isn't a brand that is commonly used by FJRForum members? There is a fine line between trash-talking a company's...

It is described as a "Hand Guard Set" - would assume both...

Mine is coil bound in two volumes. Easier to use as it stays open where you want it. Less likely to tear out compared to hole punch...

Can't remember if the signal light is combined with the running light or the brake light. In any case, the tail light assembly contains...

Front brake light switch (subject of a recall) or rear brake pivot sticking and requiring clean and grease. Sounds like brake is on all...

Michelin makes a Road 6, they dropped the "Pilot".

Michelin Pilot Road 4 GT?? Not a tire I liked much, especially the front and especially after they had a few thousand miles on them. As...

I have often thought about picking up a good low mileage Gen II engine for future possible needs. Then I would have to store it...

I appreciate your input on this and will do those checks you mentioned. If you are in central Newfoundland anytime, check in for a...

Chrystalholt,- It appears that your failure was due to corrosion because Yamaha chose not to use weatherproof connectors on this...

No way to tell how long an engine has been used. Perhaps looking at compression once you get it serviced and installed. With respect...

IIRC, the Gen II mufflers contain a catalyst element whereas the Gen I mufflers do not. Not sure about Gen III. I don't believe it...

AE Model, I assume.

Pretty normal. Especially for Rotella. Nothing to worry about. Mine does the same thing and I use Yamaha recommended drain intervals -...