Crystalholt
Member
Hi! I’m a new member & owner of a 2005 FJR 1300. Love the bike but I’m having some power issues & enjoy seeing lots of information.
Crystal
Crystal
Hello
- Thread starter Crystalholt
- Start date
Help Support Yamaha FJR Motorcycle Forum:
SacramentoMike
Not Safe For Work
Welcome, Crystal. Too much power, I suppose? JK, but if you say more about the issue somebody will be sure to come along with suggestions.
Welcome Crystal!
Ya, like Mike said, too much power? Is there a problem?
BTW you have the best FJR ever made. Take it from me, I know!
Ya, like Mike said, too much power? Is there a problem?
BTW you have the best FJR ever made. Take it from me, I know!
escapefjrtist
Searching for Dry Roads
Welcome from metro Seattle. You've come to the right place for all things FJR!
~G
~G
Crystalholt
Member
I was driving down the road in the middle of traffic & the bike powered off completely. I tried to restart, nothing. The day before same but I got it running again. I took the battery in to verify it was good & was great. I parked it & came back 5 hours later to trailer it home & it started right up. I trailered it anyways so I wasn’t caught in traffic again. I’m not sure if the headlight was on- it was a bright sunny day here in Florida.
Reluctant Samaritan
New member
Just to be clear, battery verified: did you have it professionally tested under load? My battery read 12.8 volts. I thought it was fine, but still had starting issues. I removed it; once the shop jolted it with a charge, the voltage dropped to 0.5 volts. A dead/dying battery will show intermittent signs of life. KISS - if the battery under load showed a full charge, then it's not your battery.
fastpappy
Well-known member
Welcome from the Big Apple and congrats on your new ride. Enjoy! 
Welcome Crystal, enjoy the ride. Must be pretty warm in FL this time of year?
Crystalholt
Member
Hi! Yes I took the battery in & had it test under load & it was all good. Cleaned the connections @
oh yes it’s high 80’s low 90’s! Beautiful to be riding
Crystalholt
Member
Hi! Yes I took the battery in & had it test under load & it was all good. Cleaned the connections @
oh yes it’s high 80’s low 90’s! Beautiful to be riding
wes_van
Active member
Welcome from the great white north! I saw your post about the harness, it would be for Gen 2 bike I'm afraid. Good luck with your electrical issues, if you were close I'd help you out. I do this electrical stuff for fun.
I thought that some had suggested adding a ground wire for this non-start when hot condition?
Crystal; Try looking at your insulators on the battery terminals, cable side. Years ago I had a post of my bike doing freaky things and battery going dead, nothing working, then it does. I thought I had bad gas it ran so bad. I finally found that the rubber insulators were under the terminal and making the connection extremely poor to the battery posts where barely nothing was contacting and it would come loose after a while. If they insulators are in the way cut them so nothing can be between the bottom of the terminal and your battery posts. I had pix etc, but they are gone thanks to Photo Bucket. But problem was solved!Hi! Yes I took the battery in & had it test under load & it was all good. Cleaned the connections @
oh yes it’s high 80’s low 90’s! Beautiful to be riding
