Search results

Yes the cost and procedures in Aust make it difficult - to get a VIN number adds a further complication and around 4 mths waiting for one to issue AFTER presentation for registration - the ADR book is about 4 inches thick and is for full compliance for new vehicles which an ICV or homebuilt is...

Yes rear suspension - standard bike side view shows +ve rake of swing-arm if you have mounted nose of bike lower then std for a lower profile ( as I did ) you will have a negative swing arm angle. If you notice a lot of the newer fast bikes have a pronounced +ve angle - talking to a MC race...

Item 6 has me worried - try and stop at "Little" - great to see you are progressing so well many talk a lot but produce little - Well Done ! Just a note re shortening dogbones at rear to raise trick - unless you have 200% confidence in your welding I would suggest just use two pieces of 35mm x...

OK - the gearbox proposed uses same bolts to mount - you could literally cut back the 3 tubes going to your bolting bracket plate and replace same with the gearbox and use it AS the bolting bracket- the box is quite substantial ( 4mm plate ) and I think would work. If your current system...

Hi - re cutout on corners - had the trike out for a run tonight and coming home did a sharp not overly fast corner and momentary cutout first time ever ... happened again a bit down the road hard out of a corner - looked at fuel level and was on reserve ( usually never have tank less then half...

How are you getting reverse ? - I tried many options ( that failed ) mechanical drive seems to work well - friction didn't - swing arm on to disc with cog cut didn't - the amount of drive required seems to only leave mechanical I am using 12mm gears in solid sliding application - you may end up...

Agreed didn't want constant mesh have re-engineered the unijoint yoke output with a fixed gear that will allow a sliding gear in the box to engage and then allows drive to pass - works faultlessly. I will be including a new yoke with 'box so is a true bolt up so that finished box looks factory -...

Hi Guys this is a pic of where we mounted gearbox the production version is smaller ( 100w x 100d x 150h ) but will mount to same bolts of LH footrest bracket cost should be around $650 plus post - just playing with gearing for more power - Alan

Reverse gearbox progress... Prototype is working great will post small video in a couple of days will be a simple bolt up and wire. You will need a good deep cycle battery ( taxi spec ) and heavy cable to the starter motor that operates reverse also need to run the original MC battery close to...

Sorry again missed your reply on cut out on corners - in 3000kms of very hard testing on track and road never had a problem with cut out even on the track - better look at other problems maybe - Alan

Sorry guys - fat fingers and small buttons--- why do you need to disable lean sensor on a trike just mount it as standard and all ok i would think - Alan from Aust