Search results

Just email them (only way to contact them), they do get back promptly. I damaged my sensor wire (my own fault) & needed to have it repaired. They (Phil) replied & I had my sensor wired repaired. Very good service.

As long as your knee won't hinder your ability to ride, then GO FOR IT! At least for as long as you can endure the pain (if any). I know I would, especially if the riding has been so limited as you claim with another few weeks of recouping ahead. **** I'd ride until my knee falls off.... what...

I sent it to every BMW owner I know. :P P.S. Many safe miles on your new bike.

Congrats on the purchase of the 08 Doc! :yahoo: I know the gen II bike is a few pounds heavier than the gen I, those few pounds shouldn't be that noticable. Check the air pressure of the front tire. Keep it close to the 42 psi max, especially if it's the Bridgestone. They are notorious for...

My thoughts & prayers to Richard's family & friends. Many heavenly miles may he travel!

Congrats on your new ride. Long may you both travel safely! :lol:

This is where I posted (#34) the original thread on the Honda Heated Grips Installed: War Machine's Honda Heated Grips Installed Be aware that the connector from the Honda heated grips is different from the Yamaha connector on the bike where the heated grips tie in. I changed the Honda...

Congrats on the new 08! Having had an 06 (that was rear ended & totalled) I find the 08 to also be as smooth as the 06 was after the PCIII was installed. I'm going to hang onto my PCIII because I plan to install the Holeshot headers/exhaust in the near future. I then will install a custom map...

Don't you believe that nickel & dime **** for a minute Jordylad! It's nothing but big bucks from here on out if you got the fever as bad as it sounds like you do! :dribble: P.S. Congrats!

That won't happen if you Armoral her seat. You can lose her on the first take off! :blink: Seriously....many happy & safe miles may you both travel! B)

I just read the previous 22 posts without stopping. My brain hurts so much I couldn't even focus on a tire guage now!

Only hearsay without pics! :rolleyes:

PM Sent! B)

I have this one: Nelson Rigg Defender I have this one cause I like to cover the saddlebags. It is a quality medium duty cover that holds up well. I use it everyday when I bring the bike to work. It also comes with a pouch that can be worn as a backpack.

Exactly! The 08 is just as smooth in stock form as the 06 was after the PCIII was installed. I think after my failed attempt of the BM on the 08 I best leave well enough alone. I installed the PCIII on the 08 because 1) I already had it & 2) It may become necessary to remap after I change the...

I went to the garage a little while ago & found out that the 08 bike "appears" to go into diagnostic mode, but when I tried to go to the CO settings it would not allow me to. Since what I did was unsuccessful, I undid the BM & put the wire back into slot #29 & the white pin back into slot #25...

I did the BM to my 08 this last weekend while I was installing the PCIII. I followed the instructions based on the 04 FJR which is what I believe I used for my 06. You must take the yellow wire with the red strip (#29 slot IIRC) & swap it with the white pin in slot #25. My bike both started &...

It's the powerful rear magnets on the tank bags. They affect your testicles! :blink:

+1 on the name, which should always reflect your personality! :D Congrats on the new bike. Many safe miles may you both travel!

I had the Motovation Sliders on my 06 FJR & I unfortunately know they work. There was a question if they would fit an 08, but fortunately I do know because they are on my 08 FJR. See pic: Hope I never need to use them.