Search results

Been riding for awhile. Cel icon still on.

I recently had attempted to install a front tire and had the fork bearings on wrong side causing all kinds of error codes. Once I fixed the problem, all but the cel code is left on the dash. Just tried the fault code erase using torquepro app but can't clear issue. See attachment for codes. What...

I think the collars were reversed. I swapped them around and all is good now.

Ok, I think the issue was the collars were on the wrong sides of the hubs. All lights went out except the engine which I think needs obd2 resetting. Thank you everyone for your help.

Took to a Cycle Gear shop for technician to install new tire. Clearly aware of no magnets near hub. Tire rotates in correct direction.

Tire was installed by a Cycle Gear shop technician and is going in correct direction. I was clear about no magnets near hub. When you mention "rings" are you talking about the 2 bearings? That could be the issue. I will disassemble and reverse them to opposing hub inserts. I tried to align the...

2019 es fjr 30k miles. I swapped new slippers on rear tire - no problem. Went to change the front, did it. Rode it no further than 200 yards and got a check engine lite, TCS and abs warning. What may I have messed up?

Any estimates on this cost?

Anyone buy this tent? In the shopping mode for a 2 person tent.

I ride with ASV levers.

That is a valid point too. But on the clutch side as a test to see if it works to resolve the pain may be worth a test.

I have this for my Vmax. That is an idea to test.

Vibranator bar ends?

Will do. I think the bars are swept back too far and need to straighten out. Been battling a virus for past week - very weak now.

I just wired up my ST2 system and want to run power through my PC8 fuse block. What amp fuse should I use?

Yes and I was even thinking about using a lazer level.

Now this is very smart! I will try this scientific experiment once I get my fuse block, horns and ST2 buttoned up. Thank you for the input and everyone else contributing!

Agreed. I have the low setting on the soft version OEM Yamaha touring seat.

Thanks for the input. I will look into that possibility. I know I changed the handlebars on my Vmax to "Superbars" and that made a major improvement.

Helibars were on the bike when I bought it. I believe the angle is swept back towards me to furthest point before hitting gas tank when fully rotated.