Search results

flywheel rotation on the left side of the bike on a certain speed..

did he replace also the plugs? before spend money replacing the coils personally I replace the plugs..

Why do you need adjust tps?

The '03 is fully made in Japan... That is all

Change the transmission oil with 75/90 GL5...don't know if it is the good grade for yamaha rear hub

Having a radiator guard-screen do increase engine temp. ?

Cleaned front brake master cylinder...remove the seeger that keep the piston is very hard

How much does it cost in general to have both wheels powdercoated? Mine are full of scratches...

yes infact honda bolts cost 2.5 Euro each Yamaha 13.50 each one!!!

<blockquote class='ipsBlockquote'data-author="eflyguy" data-cid="1363807" data-time="1493719094"><p> They may look perfect but if they were used, they must be replaced.<br /> <br /> Of course, you could always try them. How hard would it be to replace them if the...

Sorry guys my ignorance..I ask this because I bought a used cylinder head that comes with original bolts and they seems perfect..

Thank you Ross.

I'm not a troll. This section is techical discussion? Can I ask something?

Ok understand but...is ******* steel how is possible they stretch?

Why service manual say they must be replaced with newers if u miss the correct torque?or in a engine head install?

battery low??

I think abs module on motorbikes must be only present on the rear wheel...

I was joking... I remember on that check re-shim I found the last one exhaust valve on the cylinder 4 need a shim under the bucket of 1.50 mm. All others shims (both exhaust and intake) did range from 1.70 to 1.80 mm did someone have notice only one single valve a lot more tight than the...

I think only the rear caliper-rotor

Now my clearance is too loose.is it possible to add some material on the shims?