Disc Brake lock for security

[Luke]

A waiter question....

I want to purchase a disc brake lock and have 3 choices for the size of the rod that slides through the disc (5.5mm, 10mm, 13mm).

Which one(s) will fit? 10mm(3/8")?

 

[skyway]

A waiter question....
I want to purchase a disc brake lock and have 3 choices for the size of the rod that slides through the disc (5.5mm, 10mm, 13mm).

Which one(s) will fit?      10mm(3/8")?

Luke, since your a waiter right now, if your interested and can wait a little longer, have a look at this:

Luma disc lock

 

[Luke]

Thanks, but I have looked into the Luma lock and it apparently doesn't have lasting quality.

Anybody know what size holes are in the FJR disc?

 

[jrd14]

The holes are approximately 1/4 inch in diameter but that dosen't matter because the disc locks slip past the holes and engage through large slots in the disc which are beyond the disc holes.

 

[nusman68]

I use a Xena XN-14...

Xena

it fits perfectly, has worked just as well and I like the look of the stainless. As JRD said, the locking pin goes 'past' the brake rotor and as such is much larger diameter than a pin that would fit 'through' the rotor.

 

[Luke]

Thanks guys,

The size and slot info helps alot as well as the Xena site that gives the specs on the lock that fits. Actually that Xena-14 with the alarm sounds pretty good. I like the thought of the alarm being there if I am at a motel.

Thanks again!

 

[Toynut]

Just curious,

Will the Xena xn-14 fit an FJR with the Galfer rotors installed? :blink:

 

[dgfella]

You should get the 5.5mm pin. I bought the OnGuard Bulldog 5049 lock with an 8MM and it does not fit. It is unfortunate because this is a great lock.

dgfella