Gen 1 ABS codes 11 and 42?

[eyjohn72]

Searched and couldn't find anything. The bikes front or rear abs has not worked since I have owned it. I jumped the two test wires together and both front and rear brake pulsed, so I was happy that maybe it wasn't the $1000 solenoid that was at fault.

Took the bike down the street and the rear would still lock up. Before testing I read codes 11 and 42 before clearing. I have a service manual but not for ABS.

 

[mech 1 twa]

Code 11 as per manual Front wheel sensor signal is not received properly.

Code 42 rear wheel not recover from the locking tendency even though the signal is transmitted from ABS to release the the hydraulic state.

Trouble shooting

11 installation front wheel--front wheel sensor lead and coupler--ABS harness-- front wheel sensor rotor...............

42 Brake dragging--hydraulic unit operation test -2--rear wheel brake line.........

Don't know. Could be front ABS sensor issue. Speed sensors need to see same speeds..

Put on centerstand and 1st gear run rear wheel about 5-10 mph does ABS flash. This will tell you if rear ABS is reading.