Booniefjr1300450300
New member
GEN three with 50,000 miles. New issue is I have to hit the starter button 2 or times before the motor fires up and runs other than that the bike seems to run great
Gen 3 , have to hit the starter button two or three times before bike starts. Use to start first click every time.?
- Thread starter Booniefjr1300450300
- Start date
Help Support Yamaha FJR Motorcycle Forum:
Assuming starter spins freely all the times you press it, fuel been in the tank for a while? Pretty warm since the last time you fueled up?
It could be the switch from winter fuel to summer formulation that isn't as volatile. I know AZ is one of the states that does this.
It could be the switch from winter fuel to summer formulation that isn't as volatile. I know AZ is one of the states that does this.
Last edited:
- Joined
- Jul 3, 2015
- Messages
- 494
- Reaction score
- 649
Is the engine turning over every time you press the start button or is it dead until you press the button a couple of times?
Yes what Harper said. If it cranks but does not fire I'd say battery going bye bye. If pressing the button does nothing for a time or two, loosen the screws holding the switch housing together, pry it apart a hair and spray the insides with something like ACF-50 or De-Oxit. Don't use WD40, it's a water displacer not meant for electronics.
Booniefjr1300450300
New member
Actually, what happens is the motor spins over quickly and it fires and then stalls do this two or three times and it idles and runs fine
So when was your last tune up? Meaning oil, plugs, filters, a can of FI cleaner, etc. Is the battery strong?
MotoMike
Well-known member
What Whooshka said in post # 6.
I had the same problem on my 2007A. It started with the same symptom that got progressively worse over last summer until the bike would not even start, eventually showing fault code 12. That sent me down a rabbit hole. It turned out that I needed new spark plugs, which are recommended to be replaced every 2 years. I had let them go for 4 years.
When did you last replace the spark plugs?
I had the same problem on my 2007A. It started with the same symptom that got progressively worse over last summer until the bike would not even start, eventually showing fault code 12. That sent me down a rabbit hole. It turned out that I needed new spark plugs, which are recommended to be replaced every 2 years. I had let them go for 4 years.
When did you last replace the spark plugs?
torch
Well-known member
Could also be fuel pressure regulator or injectors. If the regulator is seeping, fuel pressure may be low in the line. If the injectors are seeping fuel pressure will be low AND there will be raw fuel sitting in the intake. Are you hitting the button as soon as you turn the key? Try waiting for the fuel pump to finish cycling.
Reliable diagnosis requires a pressure gauge. With the gauge installed, cycle the pump and watch the pressure. If it drops, plug the return line. If it holds then the issue is likely the regulator. If it still drops then the issue is likely leaky injectors.
Reliable diagnosis requires a pressure gauge. With the gauge installed, cycle the pump and watch the pressure. If it drops, plug the return line. If it holds then the issue is likely the regulator. If it still drops then the issue is likely leaky injectors.
From 2006 onward there is no return fuel line. The fuel pressure regulator is located under a separate cap on the fuel pump body inside the fuel tank. The fuel pressure regulator is not available separately from Yamaha, but it is a fairly common automotive part that is available from an auto supply or online. It's relatively cheap for the part, but requires removing the fuel pump from the fuel tank. The fuel pump housing does not need disassembling.
https://www.ebay.com/itm/191684542894
torch
Well-known member
I forgot about that, was thinking of the Gen 1. So that complicated the diagnosis slightly, but then again, at $12, it's cheap enough to do a parts swap diagnosis.
roland
New member
I have an 07 with 50K miles. Mine would start up fine then stall out everytime I began to take off. I bump started it in 2nd and it would run fine until I stopped again. Problem would occur everytime I shut if off and started out again. I thought maybe a FI was dirty and possible allowing fuel into the engine while stopped. Just before I did a long ride I put fuel injection cleaner in two fill ups on the trip. I haven't had a problem since. I got lucky.
