Never touched a bike with a wrench

[K-2]

I'd like to slightly adjust the position of my clutch lever by sliding the unit closer to the grip. Looks like two simple allen bolts do the job. Do I need a torque wrench to re-tighten (if so, how tight?) or can I just do this by feel based on how hard they are to loosen?

 

[Geezer]

If you are talking about adjusting the lever to reduce the distance between the grip and lever then no tools are required, just push the lever out slightly and turn the numbered dial that you see at the pivot point of the clutch lever. This is described in the owner's manual.

 

[K-2]

I've done that adj. I'd also like to slide it down so it is within easy reach if my hand is not choked up on the grip. I think that will require loosening the bolts.

 

[evil_henchman]

Now you tell us! Yes, it's just 2 screws and you can slide away. Welcome to the nut house :blink:

 

[K-2]

Thank....now for the long awaited answer....torque? Can I just feel it based on how tight it is when loosening, or do I need a torque wrench and a magic ft-lb number that you'll tell me?

 

[sparky3008]

Thank....now for the long awaited answer....torque? Can I just feel it based on how tight it is when loosening, or do I need a torque wrench and a magic ft-lb number that you'll tell me?

I can't quote you exact torque as I no longer have the manual. However I can't see it being anymore than 17.

However on this bolt I personally wouldn't even bother with a torque wrench. Just snug it down, just a little more than hand tight, no need to go crazy here.

On these I usually will use one hand to hold lever and the other to tighten.

Go back and forth so that one bolt isn't on more than the other.

As the lever no longer will move up and down you are almost there.

Again, no need to go crazy it doesn't take much and pay attention to the fact that the lever just doesn't move around anymore and you are almost there.

Much of the small torque stuff you learn by feel.

Good luck.

 

[K-2]

Done! And feels much better. Thanks, guys. My first try with a wrench on a motorcycle after a lifetime of dealer-only work. Hey, one has to start somewhere! Now to try my hand at mounting and wiring a GPS...here we go, this forum has ruined me.