Reply to thread

Help Support Yamaha FJR Motorcycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="RossKean" data-source="post: 1421872" data-attributes="member: 19880">I think that the part you THINK you are missing is NOT something that goes on a 2009 ABS bike!<img src="https://www.fjr1300.info/howto/images/Parts.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" />    The "T" shaped collar/spacer is something that you will see as #22 on this parts fiche. You can also see it on the photo posted above in Uncle Hud's post (#11).<a href="https://www.yamahasportsplaza.com/oemparts/a/yam/50044e2af8700209bc791546/rear-wheel" target="_blank">https://www.yamahasportsplaza.com/oemparts/a/yam/50044e2af8700209bc791546/rear-wheel</a>    A Gen I non-ABS bike was used for that rear-wheel tutorial. (Same with the parts fiche I referenced; 2004 non-ABS - compare that to the parts fiche (for the '09) that you referenced)The ABS does not have that part at all.     I suspect that you are not correctly placing the washer...    Look at this one for ABS. The washer is to the left of the cyan arrow and between the caliper holder and the thicker part of the axle. Axle goes through swingarm, then through the washer then the rear brake parts and then the ABS sensor ring housing (and then the wheel, through the "pumpkin" and out the other side). The ABS ring actually takes the place of that extra "collar" you are looking for. (The cyan arrow is pointing at the thick end of the axle.)Edit: The posted links are no longer valid - too bad!<a href="https://www.fjrtech.net/getdbitem.cfm?item=34" target="_blank">https://www.fjrtech.net/getdbitem.cfm?item=34</a><a href="https://www.fjrtech.net/getdbitem.cfm?item=34" target="_blank"><img src="https://www.fjrtech.net/images/chassis/RearWheel/sensoralignment.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" /></a></blockquote>

Verification