Twist Final drive assy??

[qbis0]

Hello,

I have problem regarding final drive assy.

As you can see on the below pictores final drive assy is twisted in relation to swing arm.

It can caused that rear wheel will be in bad position.

Can somebody check if it's the same in your FJR ?

 

[lnewlf]

I don't see any problem-my '06 looks exactly the same..The final drive unit flange is slightly smaller [@1mm] than the swingarm tube and not exactly spaced all the way around.. After all, it's not a Porshe!

 

[user 213]

qbis0 - You don't have a problem. Assemblies that need to align tightly to a specific pattern would be aligned with dowel pins, not just the studs. This is a non-critical situation.

 

[wfooshee]

Yeah, the castings don't match.

 

[FJRBluesman]

Don't ride it, it can explode!!! :dribble:

Just kidding, mine looks the same.

Maybe we all have bad final drives and need a recall.

 

[RaYzerman19]

Completely normal. If pumpkin is removed to check driveshaft, leave nuts loose until rear wheel is fully installed. It will then be properly aligned and you can tighten up the nuts.