Wanted: SS/Braided brake lines for a nonABS 05

[fjrjonesing]

wanted to buy. PM please.

Thanks-

Jim/jonesin'

 

[Warchild]

Jim, consider hitting up one of our forum sponsors for a new set of lines... they're fairly inexpensive for a non-ABS model.

VancoSport sells the exquisite HEL stainless steel lines (all three, front & rear!) for $100, shipped!

SportBikeEffects has the Galfer lines available, that is what I use on my '03 FJR....

Check our Vendor forum....

 

[fjrjonesing]

Jim, consider hitting up one of our forum sponsors for a new set of lines... they're fairly inexpensive for a non-ABS model.
VancoSport sells the exquisite HEL stainless steel lines (all three, front & rear!) for $100, shipped!

SportBikeEffects has the Galfer lines available, that is what I use on my '03 FJR....

Check our Vendor forum....

Thanks for this, Dale.

Was thinking I'd fish here first, although $100 for all the lines seems hard to beat. Think I paid about that for just the front Spiegler.

Loved how the Spieglers looked and fit. Is the quality comparable with the HEL lines?

Jim

 

[Warchild]

Loved how the Spieglers looked and fit. Is the quality comparable with the HEL lines?

Pretty close.... the fittings on the HEL lines don't "swival", but otherwise, the two brands are very comparable.

And the HEL lines come with a Lifetime Gaurantee.

Here's the VancoSport web page on them: HEL Stainless Steel lines

 

[Geezer]

I put the HEL lines on my non-ABS '05. They are very nice. Delivery was fastand they came exactly as I specified. All three lines were longer than stock so I had to figure out what to do with the extra length. That should be a plus to those who have added risers. ID of the lines is 1/8 inch (3.2 mm), which is pretty standard.

 

[fjrjonesing]

I put the HEL lines on my non-ABS '05. They are very nice. Delivery was fastand they came exactly as I specified. All three lines were longer than stock so I had to figure out what to do with the extra length. That should be a plus to those who have added risers. ID of the lines is 1/8 inch (3.2 mm), which is pretty standard.

thanks, guys. Prolly end up going this way.

jonesin'/Jim