Where to get ready made power cable for Fuzeblock

[Vtwin996]

I've ordered a Fuzeblock and was wondering if anyone knows of a source for the power cable to connect the Fuzeblock to the battery. I know it wouldn't be too hard to make up, but I'd prefer to buy one already assembled. It needs to be 2 wire, 10 or 12 guage with 'ring' connectors for the battery terminal, bare wires on the other end and an inline fuse holder on the hot wire. Probably 4-5 ft long since Fuzeblock will be under the seat.

Thanks!

 

[SLK50]

Eastern Beaver may have what you want.

 

[Bustanut joker]

I've got what you need laying on a shelf out here. Plus I have a ground set up with the same gauge wire..

Gimme a bit and I'll send you a pic if interested.

Edit; After reading below I see where 12 gauge might be better.. These I have are 10 But it's only a few wires.

 

[Bounce]

Most I know are DIY - even the fuse blocks...

 

[lonerider]

I've ordered a Fuzeblock and was wondering if anyone knows of a source for the power cable to connect the Fuzeblock to the battery. I know it wouldn't be too hard to make up, but I'd prefer to buy one already assembled. It needs to be 2 wire, 10 or 12 guage with 'ring' connectors for the battery terminal, bare wires on the other end and an inline fuse holder on the hot wire. Probably 4-5 ft long since Fuzeblock will be under the seat.

Thanks!

Don't think you'll be able to fit 10 ga. in the Fuzeblock's terminals; 12 ga. was the biggest that would go in mine.

 

[Neil San Diego]

Don't think you'll be able to fit 10 ga. in the Fuzeblock's terminals; 12 ga. was the biggest that would go in mine.

Same experience here. Since I already had the 10 gage laid in place, I "nipped" a couple of strands off the the 10 ga wire until it fit into the terminal of the fuzeblock.

 

[kolonial72]

Since I already had the 10 gage laid in place, I "nipped" a couple of strands off the the 10 ga wire until it fit into the terminal of the fuzeblock.

I'm glad to hear that I wasn't the only one to do that. Three strands off each wire, I think it was? Definitely go with the 12 ga.

 

[Vtwin996]

Thanks for all the replies. I found what I needed at Eastern Beaver. I'd been on the website, but somehow missed the page I needed.

For future references;

https://www.easternbeaver.com/Main/Products/Fuseboxes/Wiring_Kits/wiring_kits.html

 

[Bustanut joker]

Same set ups I have here only mine are 10 gauge. Heck I'd be willing to let ya have one for $5.00 and shipping.. Otherwise out they go.