WTB Gen 2 clutch slave cylinder 2D2-16381-00-00. Operational, of course! :)

[dcarver]

Title says it all...

Ran KrZy8 up on the lift and the slave cylinder started leaking...

 

[RossKean]

Do you figure it is the whole thing or just the seal?

 

[dcarver]

Most likely just the seal. The piston and 'seal' easily separated to two pieces.. just held it upside down and bang..

I have a used gen 1 will try it <again> but recall the engagement point too close to handlebar.

Looked at parts fiche, does not appear seal alone is available.

BTW, it's a well trained FJR that fails when on the lift, not on the road!

 

[TooManyBikes]

Have one from a well maintained 2012 FJR. Please PM me if your Gen 1 does not work. - which I hope does.

Best and Happy Thanksgiving Weekend.

 

[RossKean]

Looked at parts fiche, does not appear seal alone is available.

https://www.partzilla.com/catalog/yamaha/motorcycle/2006/fjr13abs-fjr13acv/clutchPart #23??

Edit: That's the shaft seal, not the piston seal. Separate part, I assume...?

 

[ahchiu]

Title says it all...

Ran KrZy8 up on the lift and the slave cylinder started leaking...

Don,
I have a gen1 which will work, it has an easier pull than gen2, I had a gen 1 on my 06.
let me know if you want it. PM me

 

[dcarver]

Don,
I have a gen1 which will work, it has an easier pull than gen2, I had a gen 1 on my 06.
let me know if you want it. PM me

Thanks ahchiu.. I have a gen 1 SC but don't like the (dis)engagement point... and the system is clean and purged. Pazzo levers. Just a little drag with lever all the way in... But Thank You for the offer!