Joe2Lmaker
Well-known member
While working on a pillion seat replacing tank for the Gen I, this was one of the resulting tangents. These started out as the second revision side supports for the tank. After deciding on a third revision for the tank supports, I offered these to txvoyager. Thanks to Kevin, these were re-purposed instead of tossed in the recycle bin!
• •
Stay tuned. This seat replacing rack will soon be sporting a Tour Tank.
I've already thought of a few improvements to this prototype:
The mounting plate should extend a little more forward, the side supports should extend a little further back, and the aluminum angle pieces should be a little longer, maybe twice as long (if they will clear the grab-rail cross member).
Time flies.
I remember the debacle four years ago when one of the vendors offered a Tour Tank mounting system. I wish I had this figured out four years ago. It could have eased a little pain an suffering back then...
Stay tuned. This seat replacing rack will soon be sporting a Tour Tank.
I've already thought of a few improvements to this prototype:
The mounting plate should extend a little more forward, the side supports should extend a little further back, and the aluminum angle pieces should be a little longer, maybe twice as long (if they will clear the grab-rail cross member).
Time flies.
I remember the debacle four years ago when one of the vendors offered a Tour Tank mounting system. I wish I had this figured out four years ago. It could have eased a little pain an suffering back then...
Last edited by a moderator: