11.2 Volts is where......

Yamaha FJR Motorcycle Forum

Help Support Yamaha FJR Motorcycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

dcarver

Well-known member
Joined
Sep 5, 2005
Messages
13,824
Reaction score
3,482
Location
Creston, CA
2017-01-14 Bad Regulator Rectifier

11.2 volts is where an FJR will no longer run.

When the volts droop, performance on throttle decreases, the ABS light will come on and then it just won't run. I made it home, barely. KrZy8 literally quit running right after she got on the lift. Thank You, KrZy8!

First things first, charge battery back up. Then troubleshoot.


Stator voltage ~70 VAC at 4k rpm, ohmed out good too. Volts out of RR connector = NFG. The smoking gun.


Kind of a PITA to remove on a 2006 Gen2. I actually pulled the rear tire, LHS shifter assembly, and the mud flap too.


Long of short, (ha!) I just happened to have a new RR in stock. Works great. Good to see 14.1 VDC again. Next step, take her out for a ride to see if adding engine heat brings the problem back.


There you have it. 11.2 VDC an FJR won't run no moh.

Just in case you happen to be sitting around a campfire with a bunch o FJR peeps and question comes up, you'll have the answer.

Of course, you'll have to prove it on your FJR to everyone there....


 
Good to know.

Hope you are sure it wan't a corroded connector or some such, that Gen 2 RR is in a dreadful place from that point of view.

Oh, yes, thanks for doing the experiment for us.

 
Last edited by a moderator:
Good to know.
Hope you are sure it wan't a corroded connector or some such, that Gen 2 RR is in a dreadful place from that point of view.

Oh, yes, thanks for doing the experiment for us.
Battery and RR connections clean as a whistle and tight. And you're right, horrible location. I noticed on my 2013 it is now located upper left hand side cowling.

 
Top