2010 for 1300

[andy1300]

Hi I have a 2010fjr and having problems starting . 

It will turn over fine . 

I have no fuel pump prime.

Also no spark.

And before and after turning over I have no imobilizer light. 

I've checked all the spiders and all going to earth.

The pump has no 12 volts at prime stage .

I've also checked the plugs and cleaned and sprayed with wd40 as a measure for prevention in the future . 

Side stand switch is ok.

The ECU does have a company name on it so im guessing it's been messed with in the past. (Key code company)

Anyone have an idea where do go next.  

Andy

 

[mcatrophy]

Run/stop switch or its wiring?

 

[andy1300]

i have no immobiliser light i wouldnt have thought the run / stop . kill switch would cause the issues im getting . saying that when i flick the switch i can hear the relay next to the abs pump clicking

 

[mcatrophy]

Probably worth checking fuses, in particular the fuel injection system fuse (see your owner's manual for its location). I have no idea why that might affect the immobiliser, but it would stop the fuel pump.

 

[SkooterG]

Ignition switch?  IIRC, there are two circuits.  One for turning starter over, and one for everything else?  Perhaps a bad wire connection to the switch?

 

[escapefjrtist]

Is this a new [to you] bike Andy or did the problem just begin? Any other strange problems before the no-start?

~G

 

[jammess]

If you have a factory service manual you can look at diagnostic fault codes and tests you can perform while in diagnostics.  Do you have a fault lamp displayed on the dash?