Corbin Front Seat - 2nd or 3rd Generation

[Laser Dude]

I bought this used, put it on my 2013, rode it for a couple hundred miles on a day trip and it did fine. Some people bash Corbin for being hard seats, and I will say that it is a hard seat, but for me, I found it to be much more comfortable than the stock seat. Your mileage (and butt) may vary. Comfort wise, my butt was happy. However, I'm 6' tall and this seat takes out the adjustment and sits lower than the low setting on the standard seat. I typically ride with my seat in the high position, and installing this seat dropped me about 2", which I didn't care for. If it sat higher, It would still be on my bike.

$140 plus $20 shipping to CONUS. It will ship FedEx Ground. I have included a lot of photos so you can be very clear on the condition of the seat. Top side is very good, there is one spot on the bottom that's shown in a photo, along with the next photo showing it from the top side, and it is not visible from the top. It was like that when I got it.

Sorry, having photo problems for some reason.Followed directions and I can't get it to work Here's a link to the entire batch of photos...

https://s1030.photobucket.com/user/LaserDudeFJR/library/Seat

Any questions, just ask.

Remember, to use this, you have to take out plastic piece that sits on the frame. It just pops loose (which is the piece that you move back and forth to set the rubber bumpers to high or low). That's not used with this seat.

 

[Gnirtsnod]

PM sent

 

[Laser Dude]

I'm pretty positive this fits a 2016, can someone confirm that nothing changed on the 2016 seat setup?

(someone is asking privately if it will fit a 2016)

 

[samamoto]

https://corbin.com/yamaha/yfjr1306.shtml

Corbin claims it does.

 

[Gnirtsnod]

PM sent