Footpeg Feeler Nuts

[flapsup]

Trembling in fear and anticipation even as I write , does anyone have a source for titanium hero nuts?

I ground off my stock ones in NC last week and thought a titanium set would make nice sparks.

That's the ones on the end of footpegs not the ones sitting in the saddle!

 

[Joe2Lmaker]

I believe in Flarduh those are referred to as "curb feelers".

 

[JamesK]

Also don't forget the hwy on-ramps

 

[jdeez1]

I have looked for sources previously without success. I actually have some Ti bar stock I was going to have cut then use a tap (or dye) I always confuse them and just put some threaded rod in. However, now that I have the Penske with 1/2" of rear ride height dialed in I touch down much less often.

 

[2WheelTiger]

I just typed "titanium bolts metric" into google and got 23 thousand results.

The internet is an interesting place.

 

[scubabiker]

"Feeler nuts." Are you hanging out with Lola again?

 

[flapsup]

I just typed "titanium bolts metric" into google and got 23 thousand results.
The internet is an interesting place.

Thanks for the steer! I had tried a dozen catalogues and motorcycle supply houses with no luck at all.