Gen 2 stock riser part

[Sportourer]

I am looking for the steel piece that goes under the stock Yamaha top triple clamp that the risers bolt to. It has two large threaded studs attached to it that come up through the triple clamp. I would also need the 2 large nuts as well. The 07 I just bought has the Helibar triple clamp and it is too upright of a position for my liking. The previous owner gave me the stock Yamaha triple clamp but couldn't find the part I am looking for. Hopefully someone has one of these they would like to part with...

Alex Schmitt
Bethel, NY
IBA#364
STOC#4028
AMA#372280

 

[kaitsdad]

Yamaha part number 3P6-26169-00-00 - ADJUSTER. Problem with that sucker is that in order to install an after market riser, you have to cut the loops to remove it from the bike. Which means it's pretty doubtful that there's a complete un-cut one sitting around. Also - re-installing it means that all of the cables and wiring looms have to be disconnected to thread them back through the loops.

You can cut the loops, bend them open, dress the cables in and then close them up again - remember to smooth the cut tips on the loops so they don't lacerate the cables and wires when you install it.

Good Luck.

 

[ahchiu]

There is a one in the F/S section, the wire loom has been cut but you can zip tie the cables, I cut my wire loom off when I installed my MV risers.

 

[Fairlaner]

use a small piece of vacuum hose to close the gap and you won't cut yourself on it......

R

 

[Eric L]

you need to sell the helibar here!

 

[owsley]

Yes, I agree, you need to sell the helibar here, and to me

Alex, welcome to the list and to FJRdom. Good luck in your search. Paul

 

[maggot]

I have what you're looking for. Send me a pm if interested..