Light button connector

[Weekendson]

Hi all, I have a stupid question, the thing is that I have an FJR1300 2008 abs (old police bike from Denmark) and I decided to repaint it. Since I had stripped of all the plastic I decided to remove the loose wireing from the police equipment. I did not pay enough attention to where the cable from the light switch (on the right hand side) so now I'm standing with the plug (brown with 3 wires) and have no idea where it should go.

Is there any one here that knows where this should plug in, I think I have looked everywhere with out any luck.

Thanks in advance.

 

[Queensland Ken]

I take it you removed that black additional police light switch on the RHS cluster ?, that would be the bikes hazard lights.

The Police RHS switch cluster & wiring loom is different to that of a normal FJR.

The "Patrol Switch" is where the normal Hazard Light Switch location is and they added a new switch for the hazard light circuit.

The Patrol Switch is a 3 position switch, the Hazard is a 2 position switch, both with the same connectors.

The Patrol Switch controls the revolving lights, plus then the siren on top of that; they are fed from the 15amp fuse in the aux police fuse block.

May be best to reinstall that switch you removed, it is the easiest option or you will have to be good with a meter and soldering iron and cut into the wiring looms.