Mounting Heat Troller knobs to clutch reservoir

[jwhite518]

I'm thinking of purchasing a Heat Troller semi-mount for my FJR, and mounting the controls on my clutch reservoir. Is there a way to mount this box other than velcro? Some kind of mounting plate that I can connect to the reservoir and then to the control box?

The Heat Troller control box can be seen in the center of this picture.

 

[NSrider]

You can use the skyway mount the can be found here https://www.bikeeffects.com/proddetail.asp?prod=Y%2DFJR%2DRDM

 

[Ignacio]

I bought a reservoir mounted switch box from BLM and put my controller inside. Here's one of them on Warchild's bike with two switches, but with a heat troller you end up having enough room for one other switch.

 

[jwhite518]

Thanks for the responses.

 

[ian]

I bought two remote units from Warm n Safe, put the boxes in the underseat tool tray (with the Audiovox cc) and mounted the knobs in the left black panel (A panel?). Be careful drilling, these panels are very fragile. I epoxied plastic backing before drilling on the new panel I bought after FUing the original one. Ian, Iowa