I bought a (slightly) used PCIII for my '06A that has the stock map installed on it. About the same time, Yamaha announced their ECU recall. I had the ECU replaced first (no real noticeable difference) and then installed the PCIII. My bike is stock except for some Remus Hexacone slip ons. When I fired the bike up, I noticed it did not respond well to off idle throttle inputs, but seemed to rev fine.
When I rode it, the bike would stall at red lights and had difficulty responding to small throttle inputs, it had to be rev'ed up more before releasing the clutch. Once going, it did feel stronger, although the power delivery did not feel smooth throughout the rev range. When I hooked up my laptop, the % throttle indicator showed 0% at idle as it should, but it still does not run right. I don't think the stock map would be causing this. Any thoughts on how to adjust it or make changes needed to get the low speed throttle response back and smooth out the power delivery ?
Thanks,
Dano
When I rode it, the bike would stall at red lights and had difficulty responding to small throttle inputs, it had to be rev'ed up more before releasing the clutch. Once going, it did feel stronger, although the power delivery did not feel smooth throughout the rev range. When I hooked up my laptop, the % throttle indicator showed 0% at idle as it should, but it still does not run right. I don't think the stock map would be causing this. Any thoughts on how to adjust it or make changes needed to get the low speed throttle response back and smooth out the power delivery ?
Thanks,
Dano