rear wheel not turning free

[pratt&whitney]

Good afternoon

I send my wheels for a tire change last friday.

I reinstall the front one without problem, but the rear is tight when i reach the torque recommended.

My ABS housing is correctly place.

Is it possible they overtight the wheel when they balanced it, and break the bearings?.

Thanks.

 

[RossKean]

More likely that it is not assembled correctly. You should be able to tell if the bearings are free to move before installing the wheel.

There is a washer that has to be in the correct place on the right side. A number of people have put it in the wrong place.

Part 21 in the attached parts fiche.

https://www.partzilla.com/catalog/yamaha/motorcycle/2006/fjr13abs-fjr13av/rear-wheel

Also see:

 

[pratt&whitney]

Hi

the 2 ball bearings turn free, and the washer is in place.

Even the thrus bearing is turn free.

Thanks

 

[mech 1 twa]

Part #9 has a slot that lines up with brake caliper mount is that correct??

 

[pratt&whitney]

Absolutely. its align.

Its turning but its rough!

 

[pratt&whitney]

I m really confuse about that, i dismantle the wheels so many time.

 

[SLK50]

Its quite easy to misplace the spacer, part #10 in the schematic

above, while the wheel is removed.

Any chance it didnt get reinstalled?

 

[pratt&whitney]

Yep, its reinstalled and we cant mismatch the washers.

 

[bigjohnsd]

Are both your brake pads on one side of the disc? Don't ask me how I know t this can happen!

 

[pratt&whitney]

Yeah, i check the brake, everything its fine.

The wheel turn fine except when i start to torque it.

Start to jam at 30-40 pounds.

 

[pratt&whitney]

Just dismantled the bearings on the wheel, needle bearing damaged.

 

[pratt&whitney]

Dismantle everything, clean and reassembly, everything is now fine till i receive my new bearings.

Thank you guys fot your help.

 

[philter]

Just dismantled the bearings on the wheel, needle bearing damaged.

How did that happen?

 

[pratt&whitney]

No clue, but the needle bearing was seized and must be change and it was dry (no lub).

I clean , lub and put it back together.

The roller bearing was good.

Tuesday i will order all the bearings,s,eals wheel collar ect