Sliders suggestions...

[FeelinJustRight]

Just installed these on Saturday...

Ditto on these sliders. I have not tested nor do I intend to, but easy install and good quality at a reasonablee price!

 

[FRJ Jc]

...and learn from my lesson... no threadlocker...

Strange as the Motivation site recomends it... I will take your word for it...

"This is an easy install with minimal tools. Manufacturer's torque specifications and locktite are strongly recommended."

https://www.motovationusa.com/mvstore/Scrip...p?idproduct=180

Jc

 

[worldbound4now]

Just installed these on Saturday...
Good news is because of the aluminum sleeve inside the slider, the effect of compression is reduced. In thoery, this means they should just stay tight when torqued properly... but as usual, check and recheck after riding.

No drama, easy install.

...and learn from my lesson... no threadlocker...

Any information on the dimensions of these sliders? I'm looking to replace my GSG MOKO sliders but am intrigued by the aluminum insert that the GSG kit lacked. My original GSG's have approximately a 2" base diameter and were about 2 5/8" tall with a 3/8" hole for the bolt.