Switched Power Source

[crankshaft]

Okay I'm trying to install a fuzeblock and need a switched power source. From my google searches I know I can use a blue green wire the powers heated grips the comes on after the bike starts or a blue wire the comes on with the key that powers the tail lights. I'm planning on using the blue wire for the tail light. I've got everything torn apart and noticd there are two looms that run back to the tail lights.

Which loom holds the blue wire that I'm looking for? Is it the bigger loom or the very small loom. I did another search trying to find that info but couldn'g find it. If there's anythin in the Bin o facts about it I missed it.

Thanks

 

[Beamer Reamer]

Here is what I did. Looking:

- under the pillion seat

- back towards the tail light area

I found where the two main tail light bulbs screw into their housings. As your looking back, I used the blue wire going into the right hand tail light. There is just a bit of blue wire sticking out of the loom and going into the tail light connector, so I cut the loom back an inch or two and then just tapped into the wire right there. Worked fine, I used a 16 ga. wire to run to the Fuzeblock.

 

[crankshaft]

Thanks. I got everything working. Fuzeblock installed!!! Working with both switched and constant power.