Who 'Dat Bracket From?

[Warchild]

Standard, factory passenger foot-peg on a first-year Gen III:

Front view... normal, OEM configuration....

Let's introduce a non-standard, non-factory bracket from the Gen I era:

Mighty pretty brackets...

I got them looooooong ago - 2004 era - never installed them.

So in this installation, I discovered that the Gen III footpeg tang is ~ 3mm wider than the Gen I equivalent. This forced me to borrow the passenger footpegs from a co-worker's 2004 FJR, and that is what resides at the lower end in these photos.

Some long-time forum member with a better memory than me will have to tell us who made these. It was a solid 12-13 years ago....

 

[puppychow]

Look an awful lot like this one:

https://www.cycle-istic.com/peg-extenders/

 

[dcarver]

WoW. Great catch PupMeister.

..and good to see Dale asking FJR questions again...

 

[RossKean]

Looks good. You'll have to get the Gen III rubber to go on top to match the driver's peg. (I think it should fit.)

 

[Harald]

I had a set of those on my 07 to increase comfort for the wife. WARNING: They did increase her comfort until I got the FJR leaned over and found they drag much too soon.

I ended up picking up a set of used MCL passenger peg lower brackets that don't go quite as far down or out.