As much as I would like to get on my soap box and rant about how badley Fred was treated, I mean, after all he is a smart guy that loves to tinker and share what he learns, and why was it he was treated so badley....but I won't go there.
I have my own variation of Fred's wire mod in that instead of using a piece of wire in the pulley groove to increase the diameter I used a piece of an O-ring. It was hard for me to get the wire in there, (anything that takes more than a minute and I'm out of patience). I used an o-ring that was .115 dia. and about 2 inches round. Cut the end on an angle to make a ramp for the throttle cable, locked the throttle wide open, (works best with the engine off), stuffed the oring in the groove tight against the cable and pressed it in the rest of the exposed groove with a screwdriver and then cut off the excess. This was very quick and easy and the oring is a squish fit so it can't come out. At least it hasn't for the last 8,500 miles. Of course you now need to readjust the throttle cable slack as it will be too tight.