Gen 3 Motorcycle Larry risers

[Madmudder]

Can anyone that has the Motorcycle Larry bar risers on a Gen 2 or 3 let me know if they have provisions to put the bar covers back on?

If you have photos that would be great thanks.The photo below does not show any provisioning to me.

https://www.motorcyclelarry.com/index.php?main_page=product_info&cPath=2_5&products_id=27&zenid=3pda4nggmdnirv3km3buao0ub1

 

[senecahome]

Not sure about Motorcycle Larry's - I bought mine used and don't know the brand.

But I believe you will find the end of the larger bolt to be drilled and tapped for the small cover mounting screws.

Glen

P.S. GenMar instructions here

https://static.twisted-throttle.net/media/files/GM.Y203.handlebar.riser.installation.instructions.yamaha.fjr1300.2006-.pdf

 

[Madmudder]

Thanks Senecahome for the reply.

The Genmar's have a hex head that may be taped but I can't determine it for sure from the photo. The Motorcycle Larry units appear to have Hex cap head bolts that would not allow for the beuty caps to be retained.

This is the reason for my inquiry.

 

[senecahome]

It's the threaded end of the bolt that is tapped. The large bolt goes up through the triple clamp with the nut on the top of the bar. You can see the hole in the picture.

 

[jayke]

The bar covers will fit back on with the MCL's. I did have to put one of the bolts on each side upside down from the instructions to make everything work though. Been on my '13 for three years now. Bought the risers a few months before the bike showed up.

 

[Madmudder]

Thank you Jayke for the confirmation.