Need GEN III under tank picture of heat shield

[Skip Irwin]

I got a feeling that I should take a picture before removing the heat shield but did not... and now I need one. Especially the right side where the throttle cables are located. I recall when removing the heat shield that the throttle cables went through the hole, but now, trying to install the heat shield, I can't see how that was true.

Thanks in advance.....

Skip

 

[Skip Irwin]

Nevermind... coming in to make this request, getting a snack, then sitting down at the bike refreshed made it all clear... the throttle cables are over the heat shield... not under.

 

[mcatrophy]

A bit late, but here you are anyway:
Click on image for larger view


(Edited to use enhanced second picture, shows run of cables better.)

 

[Skip Irwin]

A bit late, but here you are anyway:Click on image for larger view

Thank you. It was so obvious when I came back from a break.

Appreciate your help.

Skip

 

[Constant Mesh]

It appears they've added a separate atmospheric pressure sensor. In one of mcatrophy's photos in the sequence after those shown above you can see two pressure sensors atop the fuel rail.

The Gen I's had two pressure sensors. The Gen II's had one sensor. Now they've gone back to two sensors in Gen III.