Pciii & Hazard Lights

[geebrig]

Just installed a PCIII abs and during the course of installation failed to attach all four of the connectors under the tank. ( I suspect experiencing a senior moment). I attempted to fire the engine and observed two error codes and flashing turn signals. After further investigation I discovered my error and then properly attached the four wire leads. However, the flashing lites continue though the engine runs fine. I spoke to my dealer's service mgr and he had no clue except to say that I'd probably depressed the hazzard lite switch accidentally. I said there is no hazzard lite switch on this bike which puzzled him further. I believe the European bikes do have hazzard lites but there is no switch on this bike. However, there is a fuse box with the word "hazzard lite" which just adds to my confusion.

Any words of wisdom? Please step to the microphone. Thanks.

 

[Craig in Denver]

The hazard switch is the one with the yellow triangle. You don't have one??

 

[Ramblin Man]

talk about your senior moments

 

[Woodstock]

Yea, come on geebrig. Fess up.

 

[BrunDog]

Say this isn't happening!!

Unless ne plugged the PC3 into the hazard switch connector... :dribble:

-BD

 

[dgfella]

I remember reading old threads that say improperly grounding the PCIII results in bizarre behavior of the PCIII. Could it be possible that a bad ground is affecting something else (hazards) instead?

Alternatively, the secondary, auxiliary hazard switch , which Yamaha does not clearly mark, is depressed.

dgfella