Quick little "Carbon" Vinyl wrap

[jbretthorton]

My 2010 looking GenIII ish... lol

 

[Fly Bye]

Looks great.

Is the side cover next?

 

[jbretthorton]

Can't decide....

 

[Niehart]

Or the cover on the lower back of the gas tank.

 

[jbretthorton]

hummm.... yes, the lower tank cover....

 

[Warpdrv]

Sexy, nice work...

You should post link to product for those that might also like to be wannabes...

 

[jbretthorton]

I use Scotch 3M Di-Noc Carbon Vinyl

https://www.ebay.com/itm/like/270700632511?lpid=82

But I buy it local

@ $30 / linear ft (5 ' wide roll)

 

[escapefjrtist]

How much talent does it take to install...and look good?

--G

 

[jbretthorton]

I've done several wraps. Its not hard, but does require a certain technique for sure.

Combination of picking the correct sequence, heat, stretching etc...

 

[jbretthorton]

These pieces where pretty easy, clean with alcohol, start with top section first, trim just to overlap edge. Then a separate piece for the side. Just line up the "grain"

 

[escapefjrtist]

...<snip> but does require a certain technique for sure.

That's the part that always gets me!

--G

 

[Fairlaner]

it's not that hard George.

and then I had a go at the Z.....

 

[escapefjrtist]

Very nice Richard!

--G

 

[LagerHead]

Damn. Something else I "gotta" have.

 

[art miller]

Don't forget to cover that panel behind the front wheel below the radiator. While at it get the carbon fibre fender extender.

 

[fjrrrr]

There goes my entire weekend !