Suddenly hot starting very difficult and low stationairy rpm.

[Klikoo]

Dear FJR riders.

I have a 2015 FJR type RP23 with almost 32,000 km on the clock for 4 years now without any problems. At this moment I suddenly got the problem of difficult warm start. The engine runs smoothly and cold start is good. However, after refueling, for example, the warm start is very difficult. I myself suspect the mixture is too rich, I have to keep giving some gas to keep the engine running. But i am not sure about this. The battery voltage during starting varies around 11-12 volts, the starter motor runs very well. So, i think its not the battery. If I read codes according to the manual, then diagnosis code 67 was on 02. According to the manual, this must be reset, which I did. There were no other error codes. This has no effect, the situation may have become even worse. Sync adjustment was done about 10,000 km ago, it was good then. Not checked yet. The engine drives fine, only that the idle speed varies when the engine is warm and the engine has a strong tendency to stall. I have to keep giving it some gas. I can upload a video of all diagnostic codes, but code 67 is now 01. Does anyone know a possible cause?

 

[RossKean]

For the hard starting problem when hot, does the engine turn over at normal speed or is it sluggish. If slow to turn over, it may be either the starter or battery. Best check is to use a clamp-on DC ammeter to check starting current. If excessive (i.e. over 100A), the starter motor may be failing. If it is turning at normal speed, I wouldn't suspect starter or battery.

I can't help you with the diagnosis code issues - I have a Gen II which is different. Sometimes a random code may be generated when you have a failed start so these might not mean anything. Still should investigate.

I doubt it has anything to do with throttle body sync.

 

[harper]

It appears you are not the first owner. Did the previous owner install a Power Commander or other fuel mapping device? I have an '08 which developed a similar problem (always requiring a wide open throttle to start when warm) and removing the Power Commander immediately fixed the issue. The mixture was too rich while starting.

 

[RossKean]

Just occurred to me that there were some reports of problems with throttle position sensors for some Gen III bikes. You might do a little searching on the forum for this. (I thought it was earlier Gen III such as 2013-14, but may have included later bikes.) It could certainly cause starting problems (especially when hot) and uneven idle. Another thought is to check out your O2 sensor and MAP sensor.

Edit: Have a very close look for vacuum leaks...

 

[Klikoo]

Thanks for the answers. Its a generation 3 bike, 2015. I am the second owner for 4 years. The bike has run 1500 Km at the moment when a bought it almost 4 years ago. So almost new. It was, and still is in excelent condidion and complete original. At startingmoment the motor turns at normal speed, accuvoltage between 11 to 12 volts. When it starts, i have to keep some gas to keep the motor running. There is no power commander and there is no fuel mapping done or something like that. Everything is factory original and the problem suddenly arose. Driving and cold start is perfect. I am going to look for vacuumleaks and contamination of the throttelvalves? And as a wrote, there are no errorcodes in the diagnostic screen except number 67 was 02. It should be 01. The manual says idle speed control and must be reset. I have done that according the manual, but now its seems worse. The code on number 67 stays now on 01.

 

[RossKean]

Vacuum leaks, yes. Unlikely dirty throttle valves. Throttle position sensor is suspect. Same with manifold pressure sensors.