What is this for?

[fjrchik]

This lovely piece of clear 3M protective film came with my bike and I can't figure out where it goes. It really doesn't seem to fit anywhere and I'm unable to find anything in the books on it. Anyone figure this out?



Also wondering if maybe there should be an 06 discussion room on the board now? Just glancing here briefly a minute ago and there were quite a few posts about the 06s. Maybe the rest of the owners are getting a bit bored/tired of seeing and reading about them? Just a thought. Sorry, I'm an organizer!

 

[Rogue]

Thats to protect the body above the side case.

 

[FantasticJohnR]

Thats to protect the body above the side case.

I was wondering the same thing. There is only one that came with mine....

 

[fjrchik]

OK, I see where your talking about. Thanks Rogue!! Now to find another one for the other side....

 

[GPRIDER]

Should have been a set of 4 I think. My dealer put them on for me.

GP

 

[fjrchik]

I got the 4 small ones for the holes on top. This goes underneath where the locking clip from the luggage goes in.

 

[GPRIDER]

Ohhhhhh........ I guess I thought you were talking about the ones on top. Sorry Chik.

 

[twowheelnut]

Leave 'em off. They turn yellow and look for **** after a while...

 

[Mike-H]

TWN....that would depend on whether it's 3M or not...I've had 3M on mine since new & they claim it won't yellow....if its a copy or off brand then it probably will :blink: ....unless Yamaha will verify I think your rolling the dice

 

[SkooterG]

Leave 'em off. They turn yellow and look for **** after a while...

Better than scratches.

If you apply them correctly, it will help:

Make sure surface is extremely clean, as well as your hands. Mine have fingerprints form the ****** dealer that installed them.

Mix up a 50/50 or so solution of isopropyl alcohol and distilled water and put it in a spray bottle. Use this to clean the surface, your fingers, AND to thoroughly coat the 3M clear adhesive protector AFTER you have removed it from the paper backing. This won't degrade the adhesive properties, and will make sure everything is nice and clean, and make's it easier to install.

 

[fjrchik]

Says 3M all over the back of it. Thanks guys!! Now i gotta find another one. Good thing Mommy is a slave for 3M! I got post-it notes and tape for life!

 

[twowheelnut]

Better than scratches.

Like it matters on that POS you ride. :haha:

 

[SkooterG]

Better than scratches.

Like it matters on that POS you ride. :haha:

Yes, I will admit, my FJR is no longer the shiny new virgin. **** happens in 2.5 years and 65,000 miles of RIDING.

Velvet Hammer wears every battlescar with pride.

You big weenie!

 

[twowheelnut]

Er, 'Velvet Hammer'? Ladie and gents, I rest my case!

And, leave my weenie outta this, thank you.

 

[RTSR1/FJR]

Leave 'em off. They turn yellow and look for **** after a while...

oster_stupid: Yeah, leave 'em off! My '03's turned yellow and ugly, so I peeled them off!

 

[FJRmogul]

I threw away the ones for the bottom and only used the 4 on top. They haven't discolored after 2 1/2 years and there are no scratches. If they do turn yellow I'll just peel them off.

 

[lotecredneck]

Those fit the bottom opening on the '03-'05, but don't fit the '06. We left them in the side cases in case you wanted them

 

[FJRski]

Thats to protect the body above the side case.

I only got one - I thought it was to stop the whistle

 

[twowheelnut]

Thats to protect the body above the side case.

I only got one - I thought it was to stop the whistle

:rofl:

Holy crap! There's a whack of new smilies!!!