ledzepsteve
Member
- Joined
- Apr 10, 2010
- Messages
- 8
- Reaction score
- 0
Hi All,
I need help with this: I removed my drive shaft for maintenance, cleaned it up but noticed that there is only a cir clip at the end that goes into the u-joint. There is no oil seal (#34) or washer (#35). The bike is an '08 and I have had it since new, and this is the first time I have removed the drive shaft. Is the seal really missing, or is the part diagram below wrong for my bike?
I just ran down to the garage to check again, and I only see the cir_clip.
Thanks,
Steve
I need help with this: I removed my drive shaft for maintenance, cleaned it up but noticed that there is only a cir clip at the end that goes into the u-joint. There is no oil seal (#34) or washer (#35). The bike is an '08 and I have had it since new, and this is the first time I have removed the drive shaft. Is the seal really missing, or is the part diagram below wrong for my bike?
I just ran down to the garage to check again, and I only see the cir_clip.
Thanks,
Steve
Last edited by a moderator: