falcon
Well-known member
No, I really did this because I was unhappy with the bike's thermal and airflow management.
I have some news, however.
I am so sick of the TX heat that I just accepted a job in San Jose, CA. So that takes care of the heat problem! Now I have to decide if I want to put the plastics back on, or keep it and handmake my own fairing. I think I'm leaning towards keeping the bike as is, and selling the plastics. I am concerned that my mods to the bike will make it difficult to register/inspect in CA. I added my own turnsignals and bar-end mirrors...not sure how strict their vehicle inspection policies are, cause the bike looks pretty darn hacked up right now -however the engine/exhaust/emissions stuff is all completely stock.
Anyone have insight into this?
I have some news, however.
I am so sick of the TX heat that I just accepted a job in San Jose, CA. So that takes care of the heat problem! Now I have to decide if I want to put the plastics back on, or keep it and handmake my own fairing. I think I'm leaning towards keeping the bike as is, and selling the plastics. I am concerned that my mods to the bike will make it difficult to register/inspect in CA. I added my own turnsignals and bar-end mirrors...not sure how strict their vehicle inspection policies are, cause the bike looks pretty darn hacked up right now -however the engine/exhaust/emissions stuff is all completely stock.
Anyone have insight into this?
Last edited by a moderator: